Drawing showing coil winder component locations for the winder motor,
wire source spool rod, carriage motor, and carriage guide rod.
I left the hole diameters off the drawing for the components because it depends on which bearings and metal rods you choose to use.
*I choose a height of 2 13/32" for the carriage guide so the top edge of the carriage guide styrene slide tube and carriage motor threaded rod hex nut would be at the same height.
Position of carriage motor threaded rod and carriage guide with threaded coupling hex nut and carriage guide styrene tube.
Top view of side panel support.
Side view of coil winder wire guide and top and side view of the upper section of carriage base.